knowterew.blogg.se

1. #Icom 7300 ci v address rs ba1 serial#
2. #Icom 7300 ci v address rs ba1 drivers#
3. #Icom 7300 ci v address rs ba1 driver#

This output can be driven by the Spectrum Alert function. Will be used to generate a slow CW keying signal. The 'Radio Control Port' decribed further below can sometimes also be used Without using one of an emulated RTS or DTR line. IC-7300, IC-9700) can beĬontrolled via CI-V (CAT) so their USB interface can also key the transmitter, Last not least, the PTT of newer Icom radios (e.g. Alternatively (if there's no free COM port), consider using The signal actually usedĬan be selected on this control panel. Set HIGH during transmit and LOW during receive.

#Icom 7300 ci v address rs ba1 serial#

For example, the RTS line of the serial interface can be The hardware required to use this feature is exactly the same as for many The traditional method of keying the transmitter as described here. Which can control the PTT though CAT / CI-V commands still support (emulate) Not required for modern rigs where PTT control and keying canīe done via CI-V, without abusing certain lines of an RS-232 port):Įven modern rigs with built-in USB UART serial port adapter,

Note the difference between the 'Port for PTT control' (left side, These functions are selected on the 'TRX Interface' panel. If not used as normal serial interface lines, some of theĬan be used as discrete switching signals. "CI-V" (Icom's proprietary CAT protocol), etc. Some radios (like recent Icom rigs) can use the same USB port forĪudio (in/out), CAT control (computer aided transceiver or tuning) The 'serial port' may even be a virtual COM port, aka 'Null-modem emulator'. Regardless whether the transceiver uses a 'real' serial port,Ī camouflaged USB/serial port adapter, or an USB interface chip that "looks likeĪ COM port" for CAT control to the application, this chapter applies to any of them. Manufacturer doesn't supply a signed driver). Which can be cumbersome under "Windows 10" if the hardware

#Icom 7300 ci v address rs ba1 drivers#

Like 'COM ports' (if you got the required drivers running properly, These days, serial ports have almost completely been replaced by USB.īut from a software's point of view they can still accessed

#Icom 7300 ci v address rs ba1 driver#

Required no fancy driver installation, and looked as shown at the In the good old days, there was a simple 'D-Sub' 9-pin male connectorĪt the backside of each PC. To read 'Scope waveform data' from certain Icom radios as explained later. Since Version 2.94, Spectrum Lab can also use the 'Transceiver Interface' This item in the Setup dialog is used to define the COM port number whereĪ "RX/TX" (=PTT) line and other control signals can be connected.

Transceiver- and PTT control interfaces, CAT control (CI-V)